TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE.
3-28.
Governor. (Sheet 14 of 17)
INSTALLATION
17.
Install new preformed packing
(64) and plug (63) in cover (58,
Figure 3-119) to rear of governor
housing.
18.
Position new preformed packings
(62 thru 59) and cover (58) on
housing (65).
19.
Install two bolts (57).
20.
Install new gasket (56), cover
(55) and two bolts (54).
21.
Install new gasket (53), cover
(52) and two bolts (51).
22.
Install new preformed packing
(50) on body (49, Figure 3-135).
23.
Using clean oil, lubricate body
(49) lightly to outer diameter
and install in housing (65).
24.
Install new preformed packing
(48) on valve (47).
25.
Apply clean oil lightly to outer
diameter of valve (47) and
install in body (49).
26.
Install new gasket (46), cover
(45) and two bolts (44).
27.
Install insulator (43) and
tighten to 40 lb-in torque.
28.
Install nut (42) and screw (41).
29.
Install new preformed packing
(40) and plug (39).
Go to Sheet 15
Figure 3-135.
Figure 3-119.
3-157
