FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34

FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_226

FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_228

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
182

TM 5-3805-261-34 FUEL SYSTEM MAINTENANCE. 3-28. Governor. (Sheet 12 of 17) ASSEMBLY 28. Position items 103 thru 92 as an assembly (Figure 3-124) on rear of fuel injection pump. Engage lever (102) with riser (118). Engage piston (98) with fuel rack in fuel injection pump. 29. Install three bolts (91). INSTALLATION 1. Install four dowels (89, Figure 3-123) to center governor housing, if removed. Install so 0.236 inch extends beyond machined surface of housing (90). 2. Install two dowels (88), if removed. Install so 0.020 inch extends beyond machined surface of housing (90). 3. Install dowel (86) in block (87, Figure 3-134). 4. Install two nuts (84) and setscrews (83 and 82) loosely, if removed, in collar (85, Figure 3-122). 5. Install bolt (80) in block (87). 6. Install spring (81) on bolt (80). 7. Install bolt (80) with notch on end of bolt (80) in alignment with bolt (79) hole. 8. Install bolt (79) securing collar (85) to bolt (80). Go to Sheet 13 Figure 3-122. Figure 3-134. Figure 3-123. Figure 3-124. Figure 3-125. 3-155

Privacy Statement
Press Release
Contact