TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE. (cont)
3-28.
Governor. (Sheet 15 of 17)
INSTALLATION (cont)
30.
Install valve (37, Figure 3-117),
if removed.
31.
Install guide (36) approximately
0.055 inch below machined
mounting surface of housing (65).
32.
Using snap ring pliers, install
ring (35) in bore of guide (36).
33.
Using suitable driver and hammer,
install new seal (34) with lips
of new seal (34) facing inward in
guide (36).
34.
Using clean oil, lubricate lip of
new seal (34) lightly.
35.
Using suitable driver and hammer,
install new seal (38) until new
seal (38) seats on guide (36)
with lips of new seal (38, Figure
3-136) facing in.
36.
Using clean oil, lubricate lip of
new seal (38).
37.
Install sleeve (32) in lever (33,
Figure 3-137).
38.
Install nut (31) and setscrew
(30, Figure 3-138) loosely.
Go to Sheet 16
Figure 3-117.
Figure 3-136.
Figure 3-138.
Figure 3-137.
3-158