TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE. (cont)
3-28.
Governor. (Sheet 17 of 17)
INSTALLATION (cont)
53.
Install new washer (19), washer
(18), nut (17) and screw (16,
Figure 3-140).
54.
Using suitable driver and hammer,
install new seal (13) with lip
facing in.
55.
Using clean oil, lubricate lip of
new seal (13).
56.
Position new gasket (12) and
cover (11).
57.
Install six bolts (10).
58.
Install seat (9), washer (8), two
washers (7) and spring (6).
NOTE
Seat, washers and spring must
be in position on top of
lever when rear governor
housing is installed to
center housing.
59.
Position new gasket (5) and items
65 thru 6 as an assembly on
dowels (89) in housing (90,
Figure 3-110).
60.
Install bolt (4), two bolts (3
and 2) and four bolts (1).
NOTE
Return 130G Grader to
original equipment condition.
End of Task
Figure 3-110.
Figure 3-140.
3-160
