TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE. (cont)
3-28.
Governor. (Sheet 13 of 17)
INSTALLATION (cont)
9.
Position items 87 thru 79 as an
assembly on dowels (88) in
housing (90, Figure 3-121).
10.
Install two bolts (78).
11.
Install retainer (77), bar (76),
spacer (75), contact (74), spring
(73), shim (72), insulator (71),
bar (70) and two bolts (69).
12.
Adjust setscrews (83 and 82)
turning clockwise until seated.
13.
Tighten two nuts (84).
Flanged end of bolt must be
installed properly between
riser and seat when housing
is installed on fuel
injection pump. Failure to
position bolt properly will
cause engine to run at
uncontrolled high rpm.
14.
Position new gasket (68, Figure
3-120).
15.
Position housing items 90 thru 69
as an assembly on fuel injection
pump.
16.
Install bolts (67 and 66).
Go to Sheet 14
WARNING
Figure 3-120.
Figure 3-121.
3-156