FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34

FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_223

FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_225

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
179

TM 5-3805-261-34 FUEL SYSTEM MAINTENANCE. (cont) 3-28. Governor. (Sheet 9 of 17) TESTING (cont) 5. Using spring tester, test spring (107). Spring (107) must be at a length of 0.76 inch when compressed to 13.7 lbs. and return to a free length of 1.22 inch after test. 6. Using spring tester, test spring (112). Spring (112) must be at a length of 1.03 inch when compressed to 1.0 lb. and return to a free length of 1.23 inch after test. 7. Using spring tester, test spring (114). Spring (114) must be at a length of 0.427 inch when compressed 0.5 lbs. and return to a free length of 1.29 inch after test. ASSEMBLY 1. Using clean oil, lubricate bearing (127) and two races (126, Figure 3-133) at rear of fuel injection pump. 2. Install bearing (127) and two races (126) over camshaft. 3. Install dowel (125) in shaft (123). 4. Install four weights (122) and dowels (121) on carrier (124). Weights must move freely on dowels and have an end play of 0.0004 to 0.009 inch. 5. Using clean oil, lubricate shaft (123) and install in carrier (124). Go to Sheet 10 Figure 3-133. 3-152

Privacy Statement
Press Release
Contact