TM 5-3805-261-23-1
ELECTRICAL SYSTEM TROUBLESHOOTING PROCEDURES - CONTINUED
0008 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
c. Connect meter leads as shown in
1. If continuity is indicated, replace
5.
Starting Motor Is Inoperative
the illustration below and measure
starter relay (WP 0068 00).
- Continued.
continuity.
2. If continuity is not indicated, repair
circuit(s) in question (WP 0021 00). If
the problem still exists, go to Test 11.
397-2429
11. Test voltage to start switch.
a. Place battery disconnect switch in
OFF position.
b. Disconnect orange lead from start
switch BAT terminal.
c. Set multimeter to appropriate
voltage range.
d. Connect meter positive lead to
orange lead (harness side) and
negative lead to chassis ground.
0008 00-12
