TM 5-3805-293-23-4
0245
REMOVAL CONTINUED
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may result in injury or death to personnel.
N OT E
Front valve bank weighs approximately 160 lb (73 kg).
38. Attach sling and lifting device to front valve bank mounting plate (Figure 9, Item 4).
39. Remove four bolts (Figure 9, Item 2) and washers (Figure 9, Item 3) from front valve bank (Figure 9, Item 6).
40. Using lifting device, slightly raise front valve bank (Figure 9, Item 6) and front valve bank mounting plate
(Figure 9, Item 4) from front frame. Install sling on front valve bank and front valve mounting plate.
41. Using lifting device, remove front valve bank (Figure 9, Item 6) and front valve bank mounting plate (Figure 9,
Item 4) from front frame (Figure 9, Item 5). Lower front valve bank onto flat surface.
42. Remove two O-rings (Figure 9, Item 1) from front valve bank (Figure 9, Item 6). Discard O-rings.
Figure 9. Front Valve Bank.
0245
Change 1