TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2113-03 Operator In-Seat
6. Using the MSD (WP 0006), select
2113-03 Code Active - Repeat
Switch Voltage Above Nor-
Implement 120M and verify 2113-
troubleshooting code from the
mal - Continued
03 is not active.
beginning.
2113-03 Code Not Active -
Troubleshooting complete.
Test Step 2. Test for Open Rear
Chassis Wiring Harness to Trans/
Chassis ECM.
1. Connect jumper wire between cab
lower wiring harness connector P-
C2 (WP 0009, Figure 184) termi-
nal A and terminal B.
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J-1 (WP 0009, Fig-
ure 112).
3. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between rear chassis
Proceed to Test Step 4.
wiring harness connector FA-C20
Resistance 5.0 Ohms or Greater -
(WP 0009, Figure 113) terminal
Proceed to Test Step 3.
63 and terminal 70.
Resistance should be less than
5.0 ohms.
Test Step 3. Test for Open Cab
Lower Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) from cab
lower wiring harness connector P-
C69 (WP 0009, Figure 46).
0027-130