TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-08 Steering Control
Resistance 5.0 Ohms or Greater -
Position Sensor #3 Abnor-
Cab lower wiring harness is open,
mal Frequency, Pulse Width
replace cab lower wiring harness (WP
or Period - Continued
0266).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) (WP 0137) to
transmission ECM J1 (WP 0009,
Figure 112).
Proceed to step 2.
2. Using the MSD (WP 0006), select 1473-08 Code Active - Repeat
Implement 120M and verify 1473- troubleshooting code from the
08 is not active.
beginning.
1473-08 Code Not Active -
Troubleshooting complete.
Test Step 4. Test for Open Cab
Upper Wiring Harness to Imple-
ment ECM.
1. Remove jumper wire from P-C48
(WP 0009, Figure 116) terminal 1
and P-C51 (WP 0009, Figure 118)
terminal 3.
2. Connect jumper wire from P-C48
(WP 0009, Figure 116) terminal 1
and terminal 3.
3. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between cab lower wir-
Replace transmission ECM (WP
ing harness connector P-C39
0137).
(WP 0009, Figure 70) terminal 34
Remove jumper wire between P-C48
and P-C41 (WP 0009, Figure 68)
(WP 0009, Figure 116) terminal 1 and
terminal 21.
terminal 3.
Resistance should be less than
Connect the cab lower wiring harness
5.0 ohms.
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C48 (WP 0009, Figure
116) to LH joystick connector J-3 (WP
0009, Figure 117) (WP 0282).
0027-113