TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-08 Steering Control
8. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
Position Sensor #3
resistance between rear chassis
Proceed to Test Step 4.
Abnormal Frequency, Pulse
wiring harness connector FA-C21
Resistance 5.0 Ohms or Greater -
Width or Period - Continued
(WP 0009, Figure 124) terminal
Proceed to Test Step 3.
34 and FA-C20 (WP 0009, Figure
113) terminal 21.
Resistance should be less than
5.0 ohms.
Test Step 3. Test for Open Cab
Upper Wiring Harness.
1. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between cab lower wir-
Rear chassis wiring harness is open,
ing harness connector P-C69
replace rear chassis wiring harness
(WP 0009, Figure 46) terminal 51
(WP 0188).
and terminal 28.
Remove jumper wire from P-C48 (WP
Resistance should be less than
0009, Figure 116) terminal 1 and P-
55.0 ohms.
C51 (WP 0009, Figure 118) terminal
3.
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C48 (WP 0009, Figure
116) to LH joystick connector J-3 (WP
0009, Figure 117) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 2.
0027-112