TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
0615-03 was active for the
tion Angle Sensor Voltage
transmission ECM and the
Above Normal - Continued
implement 1 ECM - Replace
transmission ECM (WP 0137) and
implement 1 ECM (WP 0268).
Connect rear chassis wiring harness
connector FA-C23 (WP 0009, Figure
17) to cab lower wiring harness
connector P-C71 (WP 0009, Figure
18) (WP 0188), and install rear
bulkhead cover plate (WP 0266).
Connect rear chassis wiring harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Proceed to step 16.
16. Connect secondary steering har-
ness connector AT-C3 (WP 0009,
Figure 144) to left articulation
angle position sensor (WP 0009,
Figure 145) (WP 0257).
17. Connect rear chassis wiring har-
ness connector FA-C22 (WP
0009, Figure 47) to cab lower wir-
ing harness connector P-C69
(WP 0009, Figure 46), and install
rear bulkhead cover plate (WP
0266).
18. Connect cab lower wiring harness
connector P-C41 (WP 0009, Fig-
ure 68) to Implement 1 ECM J1
(WP 0009, Figure 69) (WP 0268).
19. Using MSD (WP 0006), select
0615-03 Code Active - Repeat
Trans/Chassis 120M and verify
troubleshooting from the beginning of
0615-03 is active.
this diagnostic code.
0615-03 Code Not Active -
Troubleshooting complete.
0027-23
