TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-04 Machine Articula-
c.
Linkage bent or damaged.
Linkage Bent or Damaged - Replace
tion Angle Sensor Voltage
articulation angle position sensor 1
Below Normal - Continued
(left) linkage and perform adjustment
(WP 0257).
Proceed to step 2.
Sensor and Linkage OK - Proceed to
Test Step 3.
2. Using MSD (WP 0006), verify
0615-04 Code Active - Proceed to
0615-04 is active for the transmis-
Test Step 3.
sion ECM or the Implement 1
0615-04 Code Not Active -
ECM.
Troubleshooting complete.
Test Step 3. Check Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect secondary steering
harness connector AT-C3 (WP
0009, Figure 144) from articula-
tion angle position sensor 1 (left)
(WP 0009, Figure 145) (WP
0257).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
4. Using MSD (WP 0006), verify
0615-04 Code Active - Proceed to
0615-04 is active.
Test Step 4.
0615-04 Code Not Active - Replace
articulation angle sensor 1 (left) (WP
0257).
Proceed to step 5.
5. Using MSD (WP 0006), select
0615-04 Code Active - Repeat
Trans/Chassis 120M and verify
troubleshooting from the beginning of
0615-04 is active.
this diagnostic code.
0615-04 Code Not Active -
Troubleshooting complete.
Test Step 4. Check Sensor Signal
Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112).
0027-25