TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
0615-04 Machine Articula-
tion Angle Sensor Voltage
Harness connector is located behind cab bulkhead cover on right rear
Below Normal - Continued
of cab.
3. Remove rear bulkhead cover
plate (WP 0266).
4. Disconnect rear chassis wiring
harness connector FA-C22 (WP
0009, Figure 47) from cab lower
wiring harness connector P-C69
(WP 0009, Figure 46) (WP 0188).
5. Disconnect cab lower wiring har-
ness connector P-C39 (WP 0009,
Figure 70) from Implement 1 ECM
J2 (WP 0009, Figure 71) (WP
0268).
6. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C39 (WP 0009, Figure
Connect harness connector FA-C21
70) terminal 41 and all other ter-
(WP 0009, Figure 124) to
minals on P-C39 and to machine
transmission ECM J2 (WP 0009,
ground.
Figure 112).
There should be no continuity.
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to articulation angle position
sensor 1 (left) (WP 0009, Figure 145)
(WP 0257).
Proceed to step 14.
No Continuity - Proceed to step 7.
7. Disconnect rear chassis wiring
harness connector FA-C5 (WP
0009, Figure 111) from second-
ary steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
0027-26
