TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-04 Machine Articula-
10. Using MSD (WP 0006) verify
0615-03 was active for the
tion Angle Sensor Voltage
0615-04 was active for the Trans-
transmission ECM only - Replace
Below Normal - Continued
mission ECM or the Implement 1
transmission ECM (WP 0137).
ECM.
Connect rear chassis wiring harness
connector FA-C23 (WP 0009, Figure
17) to cab lower wiring harness
connector P-C71 (WP 0009, Figure
18) (WP 0188), and install rear
bulkhead cover plate (WP 0266).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Connect rear chassis wiring harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Proceed to step 16.
0615-03 was active for the
implement 1 ECM only - Replace
implement 1 ECM (WP 0268).
Connect rear chassis wiring harness
connector FA-C23 (WP 0009, Figure
17) to cab lower wiring harness
connector P-C71 (WP 0009, Figure
18) (WP 0188), and install rear
bulkhead cover plate (WP 0266).
Connect rear chassis wiring harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Connect harness connector FA-C21
(WP 0009, Figure 124) to
transmission ECM J2 (WP 0009,
Figure 112).
Proceed to step 16.
0027-28
