TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-04 Machine Articula-
8. Using digital multimeter, test for
Continuity - Replace rear chassis
tion Angle Sensor Voltage
continuity between harness con-
wiring harness (WP 0188).
Below Normal - Continued
nector FA-C21 (WP 0009, Figure
Connect cab lower wiring harness
124) terminal 41 and all other ter-
connector P-C39 (WP 0009, Figure
minals on FA-C21 and to machine
70) to Implement 1 ECM J2 (WP
ground.
0009, Figure 71) (WP 0268).
There should be no continuity.
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Proceed to step 14.
No Continuity - Proceed to step 9.
9. Using digital multimeter, test for
Continuity - Replace secondary
continuity between harness con-
steering wiring harness (WP 0186).
nector AT-C1 (WP 0009, Figure
Connect rear chassis wiring harness
110) terminal 7 and all other termi-
connector FA-C22 (WP 0009, Figure
nals on AT-C1 and to machine
47) to cab lower wiring harness
ground.
connector P-C69 (WP 0009, Figure
There should be no continuity.
46), and install rear bulkhead cover
plate (WP 0266).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Connect harness connector FA-C21
(WP 0009, Figure 124) to
transmission ECM J2 (WP 0009,
Figure 112).
Proceed to step 14.
No Continuity - Proceed to step 10.
0027-27
