TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-02 Machine Articula-
9.
Remove jumper wire from har-
tion Angle Sensor Data
ness connector AT-C3 (WP 0009,
Erratic, Intermittent or Incor-
Figure 144) terminal B and termi-
rect - Continued
nal C.
10. Install a jumper wire between har-
ness connector FA-C21 (WP
0009, Figure 124) terminal 41 and
machine ground.
11. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 12.
nector FA-C22 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
47) terminal 26 and machine
Replace rear chassis wiring harness
ground.
(WP 0266).
Resistance should be less than
Connect harness connector P-C39
5.0 ohms.
(WP 0009, Figure 70) to Implement 1
ECM J2 (WP 0009, Figure 71) (WP
0268).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Proceed to step 19.
12. Remove jumper wire from har-
ness connector FA-C21 (WP
0009, Figure 124) terminal 41 and
machine ground.
13. Disconnect rear chassis wiring
harness connector FA-C5 (WP
0009, Figure 111) from second-
ary steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
0027-10
