TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-02 Machine Articula-
2. Using MSD (WP 0006), verify
0615-02 Code Active - Proceed to
tion Angle Sensor Data
0615-02 is active.
step 3.
Erratic, Intermittent or Incor-
0615-02 Code Not Active - Proceed
rect - Continued
to Test Step 6.
3. Remove jumper wire from har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal A and termi-
nal C.
4. Install a jumper wire between har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal B and termi-
nal C.
5. Using MSD (WP 0006), verify
0615-04 Code Active - Replace
0615-04 is active.
articulation angle position sensor 1
(left) (WP 0257).
Proceed to step 6.
0615-04 Code Not Active - Proceed
to Test Step 6.
6. Using MSD (WP 0006), select
0615-02 Code Active - Repeat
Trans/Chassis 120M and verify
troubleshooting from the beginning of
0615-02 is active.
this diagnostic code.
0615-02 Code Not Active -
Troubleshooting complete.
Test Step 6. Check Sensor Signal
Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect cab lower wiring har-
ness cab lower wiring harness
connector P-C39 (WP 0009, Fig-
ure 70) from Implement 1 ECM J2
(WP 0009, Figure 71) (WP 0268).
3. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from Implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0268).
0027-8
