TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0358-05 Implement Pilot
2. Using digital multimeter, measure
Resistance 5.0 Ohms or Less -
Pressure Supply Solenoid
for continuity between rear chas-
Replace cab lower wiring harness
Current Below Normal -
sis wiring harness connector FA-
(WP 0266).
Continued
C22 (WP 0009, Figure 47) termi-
Remove jumper wire between
nal 31 and terminal 32.
hydraulic valve wiring harness
There should be continuity.
connector AP-C3 (WP 0009, Figure
215) terminal 1 and terminal 2.
Connect the hydraulic valve wiring
harness connector AP-C3 (WP 0009,
Figure 215) to implement pilot
pressure supply solenoid (WP 0009,
Figure 216).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 5.
3. Using the MSD (WP 0006), select 0358-05 Code Active - Repeat
Implement 120M and verify 0358- troubleshooting code from the
05 is not active.
beginning.
0358-05 Code Not Active -
Troubleshooting complete.
Test Step 5. Test for Open Rear
Chassis Wiring Harness.
1. Disconnect the hydraulic valve
wiring harness connector AP-C1
(WP 0009, Figure 213) from rear
chassis wiring harness connector
FA-C30 (WP 0009, Figure 211).
0026-53
