TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0358-05 Implement Pilot
2. Using digital multimeter, measure
Resistance 5.0 Ohms or Less -
Pressure Supply Solenoid
for continuity between hydraulic
Replace rear chassis wiring harness
Current Below Normal -
valve wiring harness connector
(WP 0188).
Continued
AP-C1 (WP 0009, Figure 213) ter-
Remove jumper wire between
minal 5 and terminal 6.
hydraulic valve wiring harness
Resistance should be 5.0 ohms or
connector AP-C3 (WP 0009, Figure
less.
215) terminal 1 and terminal 2.
Connect the hydraulic valve wiring
harness connector AP-C3 (WP 0009,
Figure 215) to implement pilot
pressure supply solenoid (WP 0009,
Figure 216).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J2 (WP 0009,
Figure 71) (WP 0268).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Replace hydraulic valve wiring
harness (WP 0190).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J2 (WP 0009,
Figure 71) (WP 0268).
Connect the rear chassis wiring
harness connector FA-C22 (WP 0009,
Figure 47) to cab lower wiring harness
connector P-C69 (WP 0009, Figure
46) (WP 0188).
Proceed to step 3.
3. Using the MSD (WP 0006), select 0358-05 Code Active - Repeat
Implement 120M and verify 0358- troubleshooting code from the
05 is not active.
beginning.
0358-05 Code Not Active -
Troubleshooting complete.
0026-54