TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0262-03 5 Volt DC Power
5. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
Supply Voltage Above Nor-
continuity between harness con-
Proceed to step 6.
mal - Continued
nector FA-C20 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
113) terminal 11 and all other ter-
Replace transmission ECM (WP
minals on harness connector FA-
0137).
C20.
Connect accumulator sensor harness
Resistance should be less than
connector FG-C2 (WP 0009, Figure
5.0 ohms.
137) from accumulator pressure
sensor (WP 0009, Figure 138) (WP
0233).
Proceed to step 8.
6. Disconnect harness connector
FA-C12 (WP 0009, Figure 134)
from harness connector FH-C2
(WP 0009, Figure 135) (WP
0188).
7. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Replace rear chassis wiring harness
nector FA-C20 (WP 0009, Figure
(WP 0188).
113) terminal 11 and all other ter-
Connect accumulator sensor harness
minals on harness connector FA-
connector FG-C2 (WP 0009, Figure
C20.
137) from accumulator pressure
Resistance should be less than
sensor (WP 0009, Figure 138) (WP
5.0 ohms.
0233).
Proceed to step 8.
Resistance More Than 5.0 Ohms -
Replace starter wiring harness (WP
0065).
Connect harness connector FA-C20
(WP 0009, Figure 113) to
transmission ECM (WP 0009, Figure
112).
Proceed to step 8.
8. Using MSD (WP 0006), select
0262-03 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
0262-03 is active.
beginning.
0262-03 Code Not Active -
Troubleshooting complete.
0026-33