TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
6. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
tion Angle Sensor Voltage
continuity between harness con-
Replace cab lower wiring harness
Above Normal - Continued
nector P-C39 (WP 0009, Figure
(WP 0266).
70) terminal 41 and all other ter-
Connect harness connector FA-C21
minals on P-C39.
(WP 0009, Figure 124) to transmis-
Resistance should be less than
sion ECM J2 (WP 0009, Figure 112).
5.0 ohms.
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Proceed to step 19.
Resistance 5.0 Ohms or More - Pro-
ceed to step 7.
7. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from Implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0268).
8. Disconnect rear chassis wiring
harness connector FA-C23 (WP
0009, Figure 17) from cab lower
wiring harness connector P-C71
(WP 0009, Figure 18) (WP 0188).
9. Install a jumper wire between har-
ness connector P-C39 (WP 0009,
Figure 70) terminal 41 and har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 44.
10. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to step 11.
nector P-C69 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
46) terminal 26 and harness con-
Replace cab lower wiring harness
nector P-C71 (WP 0009, Figure
(WP 0266).
18) terminal 19.
Connect secondary steering harness
Resistance should be less than
connector AT-C3 (WP 0009, Figure
5.0 ohms.
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Connect harness connector FA-C21
(WP 0009, Figure 124) to transmis-
sion ECM J2 (WP 0009, Figure 112).
Proceed to step 19.
0017-49