TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
3. Turn battery disconnect switch
tion Angle Sensor Voltage
and ignition switch to the ON posi-
Above Normal - Continued
tion (TM 5-3805-293-10).
4. Using MSD (WP 0006), verify
0615-03 Code Active - Proceed to
0615-03 is active.
Test Step 6.
0615-03 Code Not Active - Replace
left articulation angle sensor
(sensor 1) (WP 0257).
Proceed to step 5.
5. Connect MSD (WP 0006). Select
0615-03 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0615-03 is active.
diagnostic code.
0615-03 Code Not Active - Trouble-
shooting complete.
Test Step 6. Check Sensor Signal
Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112).
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
3. Remove rear bulkhead cover
plate (WP 0266).
4. Disconnect rear chassis wiring
harness connector FA-C22 (WP
0009, Figure 47) from cab lower
wiring harness connector P-C69
(WP 0009, Figure 46) (WP 0188).
5. Disconnect cab lower wiring har-
ness connector P-C39 (WP 0009,
Figure 70) from Implement 1 ECM
J2 (WP 0009, Figure 71) (WP
0268).
0017-48