TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2298-05 Right Front Drive
System Response:
Pump Reverse Control Sole- All-Wheel Drive (AWD) Electronic
noid Current Below Normal Control Module (ECM) will log a diag-
nostic code and a warning will appear
on the messenger while the diagnos-
tic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Open Right
Drive Pump Reverse Solenoid.
1. Connect MSD (WP 0006). Select
All Wheel Drive 120M and verify
2298-05 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Open access door and disconnect
pump drive solenoid AX-C4 har-
ness connector (WP 0009, Figure
108) from right drive pump
reverse solenoid connector (WP
0009, Figure 109).
4. Connect jumper wire between
AX-C4 terminal 1 and AX-C4 ter-
minal 2 (WP 0009, Figure 108).
5. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.