TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2297-13 Right Front Drive
Test Step 3. Verify AWD ECM is Pro-
Pump Forward Control Sole- grammed Correctly.
noid Out of Calibration -
1. Verify AWD ECM is flashed with
Software Correct - Replace AWD
Continued
correct software (WP 0008).
ECM (WP 0270).
Proceed to step 2.
Software Incorrect - Flash AWD
ECM with correct software (WP
0008). Proceed to step 2.
2. Using the MSD (WP 0006), select
2297-13 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2297-13 is not active.
2297-13 Code Not Active - Trouble-
shooting complete.
2298-03 Right Front Drive
System Response:
Pump Reverse Control Sole- All-Wheel Drive (AWD) Electronic
noid Voltage Above Normal Control Module (ECM) will log a diag-
nostic code and a warning will appear
on the messenger while the diagnos-
tic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Shorted Pump
Drive Solenoid Harness.
1. Connect MSD (WP 0006). Select
All Wheel Drive 120M and verify
2298-03 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Open access door and disconnect
filter bypass, pump drive solenoid
AX-C1 harness connector (WP
0009, Figure 100) from pump
drive solenoid AC-C1 harness
connector (WP 0009, Figure 101).