TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2298-03 Right Front Drive
Test Step 5. Test Right Front Drive
Pump Reverse Control Sole-
Pump Reverse Control Solenoid
noid Voltage Above Normal -
Circuit for Short to Other Voltage
Continued
Source in Cab Lower Wiring Har-
ness.
1. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.
2. Using a digital multimeter, mea-
Voltage Greater than 0.3 Volts -
sure voltage between P-C35 ter-
Replace cab lower wiring harness
minal 52 (WP 0009, Figure 53)
(WP 0266).
and ground.
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AX-C1 (WP 0009, Figure
100) on AC-C1 (WP 0009, Figure
101) and close access door.
Install front engine enclosure access
panel (WP 0226).
Proceed to step 3.
Voltage 0.3 Volts or Lower - Replace
AWD ECM (WP 0270).
Connect FA-C23 (WP 0009, Figure
17) on P-C71 (WP 0009, Figure 18)
(WP 0188).
Connect FA-C35 (WP 0009, Figure
15) on P-C70 (WP 0009, Figure 16)
(WP 0188).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AX-C1 (WP 0009, Figure
100) on AC-C1 (WP 0009, Figure
101) and close access door.
Install front engine enclosure access
panel (WP 0226).
Proceed to step 3.
3. Using the MSD (WP 0006), select
2298-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2298-03 is not active.
2298-03 Code Not Active - Trouble-
shooting complete.
0014-98