TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2298-05 Right Front Drive
7. Using the MSD (WP 0006), select
2298-05 Code Active - Repeat trou-
Pump Reverse Control Sole-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
noid Current Below Normal -
2298-05 is not active.
2298-05 Code Not Active - Trouble-
Continued
shooting complete.
Test Step 5. Test Right Front Drive
Pump Reverse Control Solenoid
Circuit for High Resistance or Open
in Cab Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Remove jumper wire from P-C71
terminal 18 and terminal 12 (WP
0009, Figure 18).
3. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
4. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
Proceed to Test Step 6.
sure resistance between P-C35
terminal 52 (WP 0009, Figure 55)
Resistance 5.0 Ohms or Greater -
and P-C71 terminal 18 (WP 0009,
Replace cab lower wiring harness
Figure 18).
(WP 0266).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AX-C1 (WP 0009, Figure
100) on AC-C1 (WP 0009, Figure
101).
Connect AX-C4 (WP 0009, Figure
108) on right drive pump reverse sole-
noid connector (WP 0009, Figure 109)
and close access door.
Install front engine enclosure access
panel (WP 0226).
Proceed to step 5.
5. Using the MSD (WP 0006), select
2298-05 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2298-05 is not active.
2298-05 Code Not Active - Trouble-
shooting complete.
0014-103