TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2297-13 Right Front Drive
System Response:
Pump Forward Control Sole- All-Wheel Drive (AWD) Electronic
noid Out of Calibration
Control Module (ECM) will log a diag-
nostic code and a warning will appear
on the messenger while the diagnos-
tic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for Other Active
Codes in All Wheel Drive 120M
ECM.
1. Connect MSD (WP 0006). Select
All Wheel Drive 120M and verify
2297-13 is active.
2. Check for Active code 2297-03,
Code 2297-03 Active - Diagnose and
2297-05, or 2297-06 in All Wheel
repair code 2297-03 as described in
Drive 120M ECM (WP 0006).
this work package.
Code 2297-05 Active - Diagnose and
repair code 2297-05 as described in
this work package.
Code 2297-06 Active - Diagnose and
repair code 2297-06 as described in
this work package.
Code 2297-03, 2297-05, 2297-06 Not
Active - Proceed to Test Step 2.
Test Step 2. Calibrate Right Drive
Pump Forward Solenoid.
1. Perform AWD Pump and Motor
Solenoid Calibration (WP 0043).
2. Check for Active code 2297-13 in
Code 2297-13 Remains Active - Pro-
All Wheel Drive 120M ECM (WP
ceed to Test Step 3.
Code 2297-13 Becomes Inactive -
Troubleshooting complete.
