TM 5-3805-263-14&LP-3
VEHICLE SYSTEMS
BLADE LIFT BAR
REMOVE LIFT BAR
Tools Needed
A
1P510
Driver Group
1
start by:
a) remove centershift lock
1.
Lower the blade to the ground.
2.
Fasten a hoist to centershift cylinder (8). Remove
the bolts and cap (7) from the cylinder. Remove the
insert from the ballstud. Move cylinder (8) free of
the blade lift bar (3). Remove the insert from the rod
end of the cylinder.
3.
Remove the bolt and clip (6) from the lift bar.
4.
Fasten a hoist to the lift bar.
5.
Remove bolts (1) and lock (5) from each end of the
lift bar. Remove pins (2) and (4). Remove the
washers from between the lift arm and the lift bar.
6.
Remove blade lift bar (3). Weight is 200 lb. (90 kg).
Move the lift bar out toward the rear of the machine.
Lower it to the ground. Move the hoist free of the
frame. Remove the lift bar out the side of the
machine.
7.
Remove the seals and the bearings from each end
of the lift bar with tooling (A).
8.
Remove seal (9) from the lift bar. Remove snap ring
(10). Remove two bearings (11) and the spacer
from the lift bar with tooling (A).
3-197
