TM 5-3805-263-14&P-3
DISASSEMBLY AND ASSEMBLY
CENTERSHIFT LOCK
INSTALL CENTERSHIFT LOCK
Tools Needed
A
B
4S9447
Compressor Assembly
1
4S9181
Expander Assembly
1
1
Install 0-ring seal (2) on pin (1). Install two seals (3)
on piston (4) with tooling (B).
2.
Put the piston in position on the pin. Install the cap,
the lock and the bolts that hold the cap to the pin.
Bend the lock against the bolts.
3.
Put a small amount of SAE 30 oil on the inside
surface of housing (7) and on seal (3).
4
Put pin (1) in position in housing (7). Put the pin and
the housing in position in the blade lift bar. Install O-
ring seal (6) in the housing.
5.
Install spring (9) and the washers in housing (5).
Put the spring and housing in position on housing
(7).
NOTE: Install housing (5) with plug (10) toward the
ground.
6.
Install the bolts that hold housing (5) and housing
(7) to the blade lift bar. The bolts that hold housing
(5) and housing (7) to the blade lift bar must be
tightened evenly (a thread or two at a time) so as
not to cause damage to housing (5) from which
personal injury can be the result.
7.
Connect air lines (8) to their correct locations on the
centershift lock.
3-194
