TM 5-3805-261-34
TRANSMISSION MAINTENANCE.
14-2.
Transmission Assembly. (Sheet 13 of 20)
ASSEMBLY
16.
Install retaining ring (62),
spacer (61) and two bearing cups
(60) in drum gear (63, Figure
14-23).
17.
Install items 63 thru 60 as an
assembly on shaft (84, Figure
14-24).
18.
Heat roller bearings (58 and 57)
in engine oil SAE 30 to
temperature of 275 degrees F.
19.
Install roller bearings (58 and
57) on shaft (84).
20.
Install 3/8-16NC forged eyebolt
on bottom of transfer gear (74,
Figure 14-25).
21.
Install bar through eyebolt.
22.
Apply anti-seize compound to
threads and face of nut lock (56)
and lock nut (55).
23.
Install nut lock (56) and lock
nut (55) on shaft (84).
24.
Using a spanner socket wrench,
tighten lock nut (55) to 80 ft-lb
torque.
25.
Bend tab of nut lock (56) into
groove of lock nut (55).
26.
Remove bar and 3/8-16NC forged
eyebolt.
Go to Sheet 14
Figure 14-23.
Figure 14-24.
Figure 14-25.
14-15
