TM 5-3805-261-34TRANSMISSION MAINTENANCE.14-2.TransmissionAssembly. (Sheet 11 of 20)DISASSEMBLY63.Using puller assembly, ratchetbox wrench, bearing pullingattachment and spacer, removeroller bearing (77, Figure14-21).64.Remove preformed packing (78)from shaft (84) and seal ring(79) from under preformed packing(78) on shaft (84). Discardpreformed packing (78) and sealring (79).65.Remove and discard two seal rings(80).66.Remove two dowel pins (81), dowelpin (82) and plug (83) from shaft(84).CLEANINGClean all parts. Refer to Chapter 2.INSPECTIONInspect all parts. Refer to Chapter2.ASSEMBLY1.Install plug (83), dowel pin (82)and two dowel pins (81) on shaft(84, Figure 14-21).2.Install two new seal rings (80).3.Install new seal ring (79) andnew preformed packing (78) overseal ring (79) on shaft (84).4.Heat roller bearing (77) inengine oil SAE 30 to atemperature of 275 degrees F.5.Install roller bearing (77) onshaft (84).Go to Sheet 12Figure 14-21.14-13
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
