TRANSMISSION MAINTENANCE. (cont) - TM-5-3805-261-34

TRANSMISSION MAINTENANCE. (cont) - TM-5-3805-261-34_907

TRANSMISSION MAINTENANCE. (cont) - TM-5-3805-261-34_909

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
861

TM 5-3805-261-34 TRANSMISSION MAINTENANCE. (cont) 14-2. Transmission Assembly. (Sheet 18 of 20) ASSEMBLY (cont) 62. Install 5/8-11NC x 6 bolt through hole in one of two bearing cages (16, Figure 14-30). 63. Install dial test indicator group. 64. Pry under transfer gear (74) with a crowfoot bar to check end clearance. End clearance must be .002 to .006 inch. Add or remove shim(s) from shim pack (17) to get correct end clearance reading. 65. Remove dial test indicator. 66. Remove 5/8-11NC x 6 bolt. 67. Check end clearance in remaining set of items 84 thru 55 as an assembly. Repeat steps 62 thru 66. 68. Install two new preformed packings (16) and plugs (15, Figure 14-31). 69. Using dry ice, lower temperature of bearing cup (23). 70. Install bearing cup (23) in bearing cage (21). 71. Install shim pack (22). 72. Install bearing cage (21) on cover (28). 73. Install six washers (20) and bolts (19). Tighten six bolts (19) evenly. Go to Sheet 19 Figure 14-30. Figure 14-31. 14-20

Privacy Statement
Press Release
Contact