HYDRAULIC SYSTEM MAINTENANCE. (cont)

HYDRAULIC SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_730

HYDRAULIC SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_732

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
684

TM 5-3805-261-34 HYDRAULIC SYSTEM MAINTENANCE. (cont) 10-17. Blade Lift Cylinder. (Sheet 6 of 6) INSTALLATION (cont) 14. Install bolt (12), washer (11), clamp (10), two clips (13), spacer (9), washer (8) and nut (7, Figure 10-129). 15. Remove hoist and sling. 16. Connect hose assemblies (4 and 1, Figure 10-118). 17. Lubricate fitting (14) with clean grease. Refer to LO 5-3805-261- 12. 18. Connect battery negative ground. Refer to TM 5-3805-261-20. WARNING Only a qualified operator should perform the next steps. All other personnel must clear the immediate area. Failure to follow this procedure may cause INJURY. If you are injured, seek medical aid immediately. 19. Start engine. Refer to TM 5- 3805-261-10. 20. Move left cylinder (27) through at least five full movements of travel to bleed air from system. 21. Stop engine. 22. Inspect hose assemblies, fittings and cylinder above circle assembly for leaks. Check for excessive clearance between ballstuds and inserts. Inserts should have a snug fit on ballstud. NOTE Return 130G Grader to original equipment condition. Figure 10-129. End of Task 10-102

Privacy Statement
Press Release
Contact