TM 5-3805-261-34HYDRAULIC SYSTEM MAINTENANCE. (cont)10-17.BladeLiftCylinder. (Sheet 4 of 6)REMOVAL (cont)14.Using suitable puller, remove twobearings (24) and seals (25,Figure 10-132). Discard seals(25).15.Using suitable puller, remove twosleeve bearings (26), ifnecessary, from cylinder (27).CLEANINGClean all parts. Refer to Chapter 2.INSPECTIONInspect all parts. Refer to Chapter2.INSTALLATION1.Using arbor press, install twonew sleeve bearings (26) tocylinder (27, Figure 10-132), ifremoved.2.Lubricate two new sleeve bearings(26) thoroughly with cleangrease.3.Using arbor press, install twonew seals (25) in two caps (23)with lip on seals (25) facinginside of caps (23, Figure10-133).CAUTIONDo not use impact-type driverto install two bearings.4.Using arbor press and suitabledriver, install two bearings (24,Figure 10-132).Figure 10-132.Figure 10-133.Go to Sheet 510-100
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
