TM 5-3805-261-34HYDRAULIC SYSTEM MAINTENANCE. (cont)10-18.Articulation Cylinder. (Sheet 4 of 6)CLEANINGClean all parts. Refer to Chapter 2.INSPECTIONInspect all parts. Refer to Chapter2.INSTALLATION1.Using suitable driver and press,install two bearings (18, Figure10-138), if removed, in cylinder(19).2.Using suitable driver and hammer,install four new seals (17), twoin each end of cylinder (19),with lip side facing out.3.Position items 19 thru 17 as anassembly (Figure 10-137) onfront, left side of rear frame.NOTEUse washers as required toobtain level cylinderinstallation.4.Install three washers (16).5.Aline three washers (16), rearframe mountings and cylinder (19)eye.6.Install pin (15).7.Install washer (14), lockwasher(13) and bolt (12).Figure 10-138.Figure 10-137.Go to Sheet 510-106
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
