TM 5-3805-261-34HYDRAULIC SYSTEM MAINTENANCE.10-18.ArticulationCylinder. (Sheet 3 of 6)REMOVAL7.Using brass drift and hammer,remove pin (10).8.Separate items 12 thru 19 as anassembly from frame mounting.9.Remove three washers (11).10.Remove bolt (12), lockwasher (13)and washer (14, Figure 10-137)from front, left side of rearframe.11.Using suitable puller, remove pin(15).12Separate items 17 thru 19 as anassembly from rear framemounting.13.Remove three washers (16) anditems 17 thru 19 as an assembly.14.Remove and discard four seals(17, Figure 10-138) from cylinder(19).CAUTIONRemoval of bearings fromcylinder can cause destruc-tion of bearings. Removebearings only if inspectionindicates replacement isnecessary.15.Inspect two bearings (18).Replace if cracked, broken,distorted, grooved or worn.16.Using suitable driver and press,remove two bearings (18), ifnecessary, from cylinder (19).Figure 10-137.Figure 10-138.Go to Sheet 410-105
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
