TM 5-3805-261-34
FRONT AXLE MAINTENANCE.
5-14.
Steering Arms and Tie Rod. (Sheet 8 of 10)
INSTALLATION
8.
Lower temperature of two pins
(27, Figure 5-77) to aid in
installation.
9.
Using assembled puller assembly,
pump group, legs (2), puller
assembly, bearing puller assembly
and six spacers, install two pins
(27). Make sure grooves in two
pins (27) are in alinement with
openings in housing (37).
10.
Install two washers (26) and
bolts (25).
11.
Remove hoist and sling.
12.
Install ring (24, Figure 5-76).
13.
Using suitable driver, install
retainer (23), washer (22) and
bolt (21).
14.
Install ring (20).
15.
Install retainer (19), washer
(18) and bolt (17).
16.
Install washer (16) on socket
assembly (15, Figure 5-75).
17.
Install socket assembly (15) in
housing (37).
18.
Install nut (14) and tighten to
90 ft-lb torque. Slot in nut
(14) must aline with hole in
socket assembly (15).
19.
Install new cotter pin (13).
20.
Install washer (12).
21.
Position socket assembly (41) on
housing (37).
Figure 5-80.
Figure 5-79.
Figure 5-78.
Go to Sheet 8
5-56