FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_456

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_458

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
410

TM 5-3805-261-34 FRONT AXLE MAINTENANCE. (cont) 5-15. Wheel Spindle, Bearings and Seals. (Sheet 3 of 7) REMOVAL (cont) 11. Remove and separate ring (12) and seal (13) from housing (17, Figure 5-87). NOTE Be careful not to damage seals and rings. 12. Remove bearings (14, 15 and 16) from housing (17). CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION 1. Lower temperatures of bearings (16 and 15) to aid in installa- tion and install into housing (17, Figure 5-87). 2. Heat bearing (14) to 275 degrees F and install into housing (17). 3. Install seal (13) on ring (12, Figure 5-88). Make sure seal (13) is not twisted and is properly seated on bottom of ramp of ring (12) and against retaining lip. 4. Install seal installer on items 13 and 12 as an assembly (Figure 15-89). Go to Sheet 4 5-70 Figure 5-87. Figure 5-88. Figure 5-89.

Privacy Statement
Press Release
Contact