FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_452

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_454

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
406

TM 5-3805-261-34 FRONT AXLE MAINTENANCE. (cont) 5-14. Steering Arms and Tie Rod. (Sheet 9 of 10) INSTALLATION (cont) 22. Install nut (11) and tighten to 90 ft-lb torque. 23. Install new cotter pin (10). 24. Connect battery negative grounds. Refer to TM 5-3805-261-20. WARNING Only a qualified operator may perform the following procedure. All other personnel must clear the immediate area. Failure to follow this procedure may cause INJURY. If you are injured, seek medical aid immediately. 25. Start engine. Refer to TM 5- 3805-261-10. 26. Operate wheel lean control lever to position rod assembly (9) in line with pin (8, Figure 5-74) on right front of vehicle. 27. Stop engine. 28. Disconnect battery negative grounds. Refer to TM 5-3805- 261-20. 29. Position pin (8) through eye of rod assembly (9) on right front of vehicle. 30. Install retainer (7), washer (6) and bolt (5). 31. Install lock (4), bolt (3), washer (2) and nut (1). Tighten nut (1) to 185 ft-lb torque. Figure 5-75. Figure 5-74. Go to Sheet 10 5-66

Privacy Statement
Press Release
Contact