FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_453

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_455

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
407

TM 5-380-261-34 FRONT AXLE MAINENANCE. 5-14. Steering Arms and Tie Rod. (Sheet 10 of 10) ADJUSTNENT 1. Install wheel spindles. Refer to paragraph 5-15. 2. Install front wheels. Refer to TM 5-3805-261-20. 3. Raise front axle off ground with jack and support with two Jack stands (Figure 5-81). 4. Using a piece of chalk to mark the center of the treads of both tires, rotate and mark front tires on front of vehicle. Tires should be facing straight ahead. 5. Measure distance between front centers and rear centers of tires. Measurement at the front of the tires should be 0.12 to 0.25 inch less than the measurement at the rear of the tires (Figure 5-82). 6. Loosen lock nut (38, Figure 5-83) if adjustment is necessary. 7. Turn steering tie rod (42) in direction needed to obtain the distance required. 8. Tighten lock nut (38) to 55 ft-lb torque. 9. Lower front axle to ground and remove jack and two jack stands. NOTE Return 130C Grader to original equipment condition. Figure 5-81. Figure 5-82. Figure 5-83. End of Task 5-67

Privacy Statement
Press Release
Contact