TM 5-3805-261-34
FRONT AXLE MAINTENANCE. (cont)
5-14.
Steering Arms and Tie Rod. (Sheet 3 of 10)
REMOVAL
1.
Remove nut (1), washer (2), bolt
(3) and lock (4, Figure 5-74)
from wheel lean arm on right,
front of vehicle.
2.
Remove bolt (5), washer (6) and
retainer (7).
CAUTION
Do not remove pin from wheel
lean, lean arm or lean bar.
3.
Remove pin (8) from leaning wheel
rod assembly (9). Drive out pin
(8) with hammer and punch just
far enough to clear rod assembly
(9).
4.
Connect battery negative grounds
to batteries. Refer to TM 5-
3805-261-20.
WARNING
Only a qualified operator may
perform the following
procedure. All other
personnel must clear the
immediate area. Failure to
follow this procedure may
cause INJURY. If you are
injured, seek medical aid
immediately.
Figure 5-74.
5.
Start engine. Refer to TM 5-
3805-261-10.
6.
Operate wheel lean control lever
to retract rod assembly (9) into
cylinder. Refer to TM 5-3805-
261-10.
Go to Sheet 4
5-60