TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE. (cont)
3-28.
Governor. (Sheet 5 of 17)
REMOVAL (cont)
31.
Remove bolts (66 and 67, Figure
3-120) from fuel injection pump
and governor center housing.
32.
Separate items 69 thru 90 as an
assembly and gasket (68) from
fuel injection pump. Discard
gasket (68). Remove all gasket
material from mounting surfaces.
33.
Remove two bolts (69), bar (70),
insulator (71), shim (72), spring
(73), contact (74), spacer (75),
bar (76) and retainer (77) from
housing (90, Figure 3-121) and
separate.
34.
Remove two bolts (78) and items
79 thru 87 as an assembly from
housing (90).
35.
Remove bolt (79), bolt (80) and
spring (81) from collar (85,
Figure 3-122).
NOTE
Remove setscrews and dowels
only if inspection indicates
replacement is necessary.
36.
Remove setscrews (82 and 83) if
necessary, two nuts (84) and
collar (85).
37.
Remove dowel (86) from block
(87).
38.
Remove two dowels (88) and four
dowels (89) from housing (90,
Figure 3-123) if necessary.
Go to Sheet 6
Figure 3-120.
Figure 3-121.
Figure 3-12.2
Figure 3-123.
3-148
