TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE. (cont)
3-25.
Fuel Injection Pump. (Sheet 9 of 16)
DISASSEMBLY (cont)
CAUTION
Do not remove dowels unless
replacement is absolutely
necessary.
32. Using hammer and punch, remove
four dowels (52).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter
2.
ASSEMBLY
1.
Using suitable driver and hammer,
carefully install and tap four
dowels (52) into position in
housing (53, Figure 3-93).
Dowels (52) must be installed
extending beyond cylinder wall to
dimensions.
2.
Install four new preformed
packings (51) on grooves of pins
(50, Figure 3-94). Lubricate
with clean oil.
3.
Using suitable driver and hammer,
install four pins (50) into
housing (53) until pins seat with
counterbore.
4.
Install new preformed packing
(49) and plug (48).
5.
Install two new preformed
packings (49) and plugs (46).
Go to Sheet 10
3-124
Figure 3-93.
Figure 3-94.
