FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34

FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_194

FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_196

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
150

TM 5-3805-261-34 FUEL SYSTEM MAINTENANCE. 3-25. Fuel Injection Pump. (Sheet 8 of 16) DISASSEMBLY CAUTION Do not remove bearings from housing unless replacement is necessary. 24. Using suitable puller, remove bearings (42 and 43). 25. Using suitable puller, remove bearing (44). Install locator plate so large bore in plate is in alinement with counterbore for preformed packing (13) and the small hole in the plate is over bearing (44). Scribe a mark on the plate. This mark will aid in proper installation of bearing (44). 26. Using suitable puller, remove bearing (45). 27. Remove items 46 thru 53 as an assembly. 28. Remove two plugs (46) and preformed packings (47, Figure 3-92). Discard preformed packings (47). 29. Remove plug (48) and preformed packing (49) from housing (53). Discard preformed packing (49). 30. Using hammer and punch, drive four pins (50) out from opposite side. Take care not to damage any machined surfaces. 31. Remove and discard four preformed packings (51). Go to Sheet 9 3-123 Figure 3-92.

Privacy Statement
Press Release
Contact