TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE. (cont)
3-25.
Fuel Injection Pump. (Sheet 3 of 16)
REMOVAL
NOTE
Cap all open fuel ports and
individual injection pumps to
prevent contamination.
1.
Remove cotter pin (1) and pin (2,
Figure 3-84) from right side of
engine. Discard cotter pin (1).
2.
Disconnect linkage assembly (53)
from fuel injection pump and
governor control lever. Move
linkage assembly (53) out of the
way.
3.
Remove governor control lever.
Refer to paragraph 3-30.
NOTE
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends to prevent
contamination.
4.
Disconnect hose assembly (3) from
fuel injection pump.
5.
Remove elbow (4) and preformed
packing (5). Discard preformed
packing (5).
6.
Remove hose assembly (6).
7.
Remove manifold shield. Refer to
paragraph 3-19, step 1.
8.
Remove three nuts (7).
Go to Sheet 4
3-118
Figure 3-84.
