TM 5-3805-261-34
ENGINE MAINTENANCE. (cont)
3-7.
Timing Gears and Plate. (Sheet 7 of 9)
INSTALLATION (cont)
18.
Install 3/8-16NC bolt in flywheel
again.
19.
Observe rocker arms for No. 1
piston through breather hole
in valve cover. Check if both
rocker arms move freely.
20.
Repeat steps 17 thru 19 if rocker
arms do not move freely. If
rocker arms move freely, continue
to next step.
21.
Remove four bolts (20), washers
(21), cover (22) and gasket (23,
Figure 3-31) from fuel pump
housing. Discard gasket (23).
Remove all gasket material from
mounting surfaces.
22.
Install bolt (1, Figure 3-32) on
fuel injection pump camshaft.
23.
Install pin in fuel injection
pump housing (Figure 3-33).
24.
Push on pin and turn fuel
injection pump camshaft until pin
slides down into groove in
camshaft. Fuel injection pump is
now in No. 1 piston top center
position.
25.
With pin still in camshaft
groove, remove bolt (1, Figure
3-32) from fuel injection pump
camshaft.
Go to Sheet 8
3-44
Figure 3-33.
Figure 3-32.
Figure 3-31.
