ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_112

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_114

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
68

TM 5-3805-261-34 ENGINE MAINTENANCE. 3-7. Timing Gears and Plate. (Sheet 4 of 9) REMOVAL 8. Remove six bolts (12), locks (15), plate (13) and gasket (14, Figure 3-26) from engine block. Discard gasket (14). Remove all gasket material from mounting surfaces. CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION NOTE Before installing plate, make sure that preformed packing for the fuel injection pump housing are properly positioned. 1. Install new gasket (14, Figure 3- 26) on cylinder block. 2. Trim gasket (14) even with bottom of cylinder block. Apply gasket cement to bottom of gasket (14) where it touches gasket for oil pan plate. 3. Install plate (13), locks (15) and six bolts (12). 4. Install three washers (11) and nuts (10, Figure 3-25) on studs that hold fuel injection pump to plate (13). Go to Sheet 5 Figure 3-26. 3-41

Privacy Statement
Press Release
Contact