ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_117

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_119

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
73

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 3-7. Timing Gears and Plate. (Sheet 9 of 9) INSTALLATION (cont) 35. Install 3/8-16NC bolt into flywheel again. 36. If flywheel bolt is installed and pin is in groove of pump camshaft, the gears timing is correct. If so, go to next step. If not, repeat steps 30 thru 36. 37. Remove 3/8-16NC bolt from flywheel. 38. Install plug (19, Figure 3-30). 39. Install new gasket (23), cover (22), four washers (21) and bolts (20, Figure 3-31) on fuel injec- tion pump housing. Torque bolts to 20 + 5 ft-lb. 40. Position breather (18, Figure 3-29) on valve cover. 41. Tighten two clamps (15). 42. Install bolt (16) and tighten to 10 + 2 ft-lb torque. NOTE Return 130G Grader to original equipment condition. End of Task Figure 3-31. Figure 3-30. Figure 3-29. 3-46

Privacy Statement
Press Release
Contact