TM 5-3805-261-34
ENGINE MAINTENANCE.
3-7.
Timing Gears and Plate. (Sheet 8 of 9)
INSTALLATION
26.
Position gear (3, Figure 3-20) on
fuel injection pump camshaft.
27.
With the flat side of the washer
away from the gear, install washer
(2) and bolt (1). Bolt (1) should
be finger tightened.
28.
Install adapter on gear (3).
29.
Using two torque wrenches, put a
clockwise force of 50 ft-lb on
adapter to remove gear backlash,
while bolt (1) is tightened to
199 + 18 ft-lb torque.
30.
Remove pin from fuel injection
pump housing (Figure 3-33).
31.
Remove 3/8-16NC bolt from
flywheel.
NOTE
Steps 32 thru 38 are to
recheck timing to insure it
is correct.
32.
Turn crankshaft clockwise (as
seen from front of engine)
approximately 1/2 turn.
33.
Install pin in fuel injection
pump housing.
34.
While crankshaft is turned
clockwise (as seen from front of
engine), push pin until it slides
into groove on fuel injection
pump camshaft.
Go to Sheet 9
Figure 3-20.
3-45